The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers.
This version of the controller is our new direction in the development of the stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.
iPower Motor GM5208-12 Brushless Gimbal Motor
The GM52 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras.
This motor is designed for large-scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque.
The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Motor Out Diameter: Ф63±0.05mm
Motor Height: 22.7±0.2mm
Hollow Shaft(OD): Ф15-0.008/-0.012 mm
Hollow Shaft(ID): Ф12+0.05/0 mm
Wire Length: 610±3mm
Cable AWG: #24
Motor Weight: 195±0.5g
Wire plug: 2.5mm dupont connector
No-load current: 20V
No-load volts: 0.09±0.1 A
No-load Rpm: 456~504 RPM
Load current: 20V
Load volts: 1A
Load torque(g): 1800-2500
Motor internal resistance: 15.2Ω±5%（Resistance varies with temperature）
High voltage test: DC500V 10mA @1sec
Rotor housing runout: ≤0.1mm
Steering (axle extension): clockwise
High-low temperature test:
High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Maximum power: ≤40W
Working current: 3-5S
Working temperature: -20~60℃;10~90%RH
3 x GM5208-12 Gimbal Motor
1 x Alexmos 32BIT BGC set without alum case
1 x Connecting cables set