GM2804H-100T Combo Set

The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers.

This version of the controller is our new direction in the development of the stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.

Model: GM2804

Motor Out Diameter: Ф35±0.05mm

Motor Height: 15±0.2mm

Hollow Shaft(OD): Ф8-0.008/-0.012 mm

Hollow Shaft(ID): Ф6.5+0.05/0 mm

Wire Length: 60±3mm

Cable AWG: #24

Motor Weight: 42.3±0.2g

Wire plug: PH3P connector

No-load current: 10V

No-load volts: 0.09±0.05 A

No-load Rpm: 1602~1771 RPM

Load current: 10V

Load volts: 0.8A

Load torque(g): 250-350

Motor internal resistance: 9Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤25W

Working current: 2-3S

Working temperature: -20~60℃;10~90%RH

3 x GM2804-100T Gimbal Motor

1 x Alexmos 32BIT BGC set without alum case

1 x Connecting cables set