iFlight Original BaseCam SimpleBGC 32-bit Extended Gimbal Controller featured built-in frame IMU, a current sensor to measure battery power consumption, CAN-bus to replace I2C for the IMU sensor and other periphery connection.
*Built-in Frame IMU
*Current sensor to measure battery power consumption
*CAN-bus to replace I2C for the IMU sensor and other periphery connection
*Dedicated 3x SPI/PWM ports for encoder connection
*Additional I2C port to connect 2nd IMU or encoders
*Built-in sound beeper
*Up to 6s LiPo battery is supported
Size of the board: 50×50 mm
The distance between the mounting holes: 45 mm
The diameter of the mounting holes: 3mm
Power supply voltage: 8-26 V (3s-6s LiPo)
Maximum motor current: 1,5 A
5V output current to power external devices: up to 1 A
3V output current: 150 mA
iPower Motor GBM5208H-200T Brushless Gimbal Motor
The GM52 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras.
This motor is designed for large-scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque.
The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Hollow Shaft Diameter (mm):12.6mm
- 3x iPower GM5208-12 Gimbal Motor
- 1 x Alexmos 32BIT Extended BGC set with alum case
- 1 x Connecting cables set
Connecting encoders to the regular SimpleBGC 32bit board